Lightweight Lining Ropes

[Black_Fly]

My lining ropes are heavy. The material holds water, doesn’t float like I thought. It’s not a big deal, except when tripping, carrying everything on my back. I was able to dodge one 35 rod portage in the whole trip. Had water been a little higher, there would have been more.

What material & construction do you like for lining ropes? A source would be appreciated too, since it’s tough online to know exactly what you’re getting.

Thanks.

 

[Gamma1214]

I've started using 1/4 inch braided polyester rope for painters and just cut the 100 ft roll in 1/2. It doesn't add much weight but I'm not certain that it floats either.

Alternatively, I've used 1/8 inch diameter paracord which weighs (practically) nothing and I always have lots of it around. Much like the Frank's RedHot commercial says: "I put that $hit on everything" (I'm almost certain that it does not float though)

 

[dutchlennart]

northwater offers all their lines by meter/foot it depends a lot where i paddle what rope i bring on flat/slow deep water 6 mm is fine . on whietwater where the rope could also end up beingused isn salvaging swamped pinned boats. 10mm

 

[ScottS]

I use rescue rope. It floats. You can get it in 1/4 inch if you want something thin. I have bought mine
from NRS. I think a painter should float, and a lining rope should float for sure. It's cheap, compared to what your canoe is worth.

Search for rope at nrsweb.com

Search NRS for rope

www.nrs.com

 

[dramey]

I use 1/4” braided polypropylene ropes. Waterproof, floats, very low stretch and cheap in price.

 

[recped]

First thing is that rescue rope used in a pin recovery and lining rope are rarely the same thing.

Lining rope (and painters) should float ALWAYS, the last thing you want is a rope that doesn't float that can get tangled up with underwater rocks or tree debris.

If you want to save your hands lining rope should be at least 3/8th (10mm or more, I prefer 11 or 12mm)

Lining ropes should be neither overly long or too short.

I use my painter lines which I prefer to be 1 - 2 meters/yards longer than the length of the boat so that you can have a good grip of both ropes regardless of which end of the canoe you are at and avoid having a mass of rope to get tangled in.

Unlike in a pin situation using a z-drag where stretch is not desirable a little stretch in lining/painter rope is ok.

If you encounter a situation that truly requires longer rope it's time to get out your throw bag, that rope is usually 70ft (anything shorter is next to useless for their intended use).

Poly is preferred over nylon which is subject to UV deterioration.

 

[Black_Fly]

The CF trim on my NW Solo omits the crossbar handles which I usually coil my ropes on. I’m thinking about boring a hole in the integrated handle to coil the live end of painter/lining rope to.