If there isn't a canoe trip...

[kahel]

then at least a few days of sailing

That's how it'll be... once it's ready.

. .

. .



But there's still a bit of work to be done before Wilma can float on the water.

 

[Boatman53]

A sail rig with a jib, nice.
Just an observation, you might want to move those stays aft of the mast a bit. They are fine side to side but they do nothing to keep the mast falling forward. What is the mast step and how secure is it?
You are in for some fun.
Jim

 

[kahel]

@Boatman53

The pictures shown are just a sort of test setup for now... to see if it works.
I'll have to figure out how to design the mast base over the next few days - I can't say anything more specific about it today.
Should the shrouds be moved a bit further aft?
Hmm... let's see how I can work that out.
Since the Wilma has a keel on the outside, it has a sort of hollow strip on the inside, which will make it difficult to glue the mast base in place.

.

Likewise, I'm still not sure what the mast base should ultimately look like.
Right now, I'm leaning toward a rectangle with a slot for the mast end so that I'll have enough surface area on both sides of the hole to glue it down securely.

Thanks for the suggestions.

 

[ppine]

I agree about adding fore and aft stays.
You are also going to need leeboards so you can reach.

 

[kahel]

Once I'm done with the mast base, I'll move on to the centerboard. Then I'll work on the leeboard. I think I'll just build one to see if that's enough...

 

[stripperguy]

We've discussed some of this before...

Basic Leeboard Info?

I know little to nothing about leeboards. The closest I have come is downwind sailing while holding a semi vertical paddle blade rudder. That is quite unnecessarily tiring. My leeboard questions are novice elementary. Where, fore and aft, on the hull is the lee board best located? I presume by...

www.canoetripping.net

 

[kahel]

My idea for the mast base was to take a rectangular piece of wood and glue it in place.
It will have a hole in the center to accommodate the end of the mast.
It will taper outward from the center so that the outer edges don’t stick up too much.
It will be wide enough to provide sufficient support and a large enough surface area for gluing.
Because of the keel, there’s a sort of keel groove on the inside, so gluing it in will be a bit of an “artistic challenge"...

Here is the result:

. . .

. . . .

. . . .

 

[Steve in Idaho]

Without a taller mast, a backstay is out of the question with that mainsail. Unless you want to change the sail plan to a simple sloop rig, just move the shrouds aft about ten inches.

 

[Dana]

There were two sailing canoes on the lake when I was a kid, one wood and one aluminum Grumman. Neither had any stays IIRC; just the thwart and base supported the mast, which is more than adequate for the amount of sail a canoe can carry. The leeboards attached to the ends of the mast thwart, which attached to the top of, and extended slightly beyond, the gunwales.