Boatman53

My pond finally cleared of ice so I was able to soak the spruce inwales for a couple of days. I made two jigs for bending and then I...

Stems notched for ribs and rough tapered.

I saw a car going down the road with a canoe cross wise like that, he was about a 1/2 mile from an outfitter and I’m guessing they...

What I remember most from a trip to Quetico was humping someone else's cast iron pot and lid so we could have a walleye chowder one...

I second that. Jim

I just want to give a very long Overdue Thank You to Glenn ! You have immensely improved this Site ! It is so much easier to start a...

Thanks Jim. Quite the post. I like how you used the station forms to press down the insert. Well done. Jim

OK . At this point the Kevlar copy is off the stripper mold. Next up is to sand the glassed stripper, before removing from the forms...

This is a Home Depot pole project, Hemlock i believe and im heading into this open minded and willing to “up-grade” my equipment if...

It’s really hard to see/understand all that was sanded too much. My earlier comment of it looks like you need to build another boat...

I went to Humboldt State University and graduated with a wildlife management degree in 1989. My graduation study was tied into a...

Welcome Microtus, pull up a stump there is plenty of room by the fire. This is the best group of people I’ve met on the Internet...

The big boxes have it but they charge an arm & a leg for it, I'd have to hunt through a pile of it to get nice boards, I try to buy...

Looks like you need to build another boat (once this one is finished). Jim

Epic. Can’t wait to see your progress!! For me in-depth research into a topic can help spend my interest and save me a bunch of money...