Jim Dodd's latest activity

I forgot to mention, Jim, I can't see the picture: tried refreshing the browser. Maybe it's just on my end! Cheers

^Picture's worth a thousand words!

Makes sense, and since most of my fiberglassing experience is with laminating over foam I certainly understand that the main strength...

I've delved into this a few times, over the years. If you are cutting strips from 1X stock ? Purchase Flat grain, or Slash cut planks...

Thanks for the feedback. Some observations: Timing The Titebond II tacks pretty quickly so going up the sides I did a strip on one...

The Clipper construction seems quite robust despite being lightweight. I thought the seat hangers were powder coated aluminum but it...

Nice ! Stapleless always presents the challenge, of keeping the strips true to the forms. When you release the clamp ? The strips...

Here's a better picture that shows the two together. I assume these are made by Clipper as they are what came on my Caribou S. These...

Yeah, I mapped the thwart placement, for my Bell gunnels. The only way I could get them to bend, to follow the shape of the shear. So...

Great to get it done ! Good we still have open water to paddle. Okoboji, should be a little quieter, than the last time we paddled it...

Well, this canoe is finally wrapped up. Turns out I don't really have the desire to build canoes anymore. It sat untouched for a long...

It's 13' long with a 32.5" beam. Symmetrical hull with a bit of rocker. The hull was made from cottonwood. The trim is all walnut...

Carbon is hard to see, if it wetted out fully, during infusion. I'd contact the manufacturer, and see if they would at least repair...

I used aluminum gunnels on my composites. The Bell type. Great gunnels, but they are stiff, as they should be. This is not a complaint...

I laminated the two cedar strips for the inside and put them on together. I was hesitant to glue all three as I didn't know how easily...