dogbrain

I finally bought the book earlier this year. Yes, the drawings and maps are great. Most of the maps have so much information on them...

Two years after a tragedy on Shoshone Lake, rangers reveal details of the search for two lost canoeists, including one who remains...

I did a solo trip from that entry point a dozen years ago in mid September. I did a counter clockwise loop going east through Hustler...

I have repaired a few gel coat canoes. In the scheme of things it isn’t all that difficult. The problem is getting a color match. It’s...

Raka uv epoxy resin does a good job. Even so, you’ll ultimately want to cover epoxy with paint or varnish. Mark

A flush trim bit might work but since it's cedar and the strips are thin it takes hardly any time with a planer. Alan

There are a couple of Kite builds documented on this forum including mine and Stripperguys. Here are 3 pictures from the Kite plans that...

There you have it. Three perfectly good ways to cut strips. This short thread has covered the full extent of that topic. Just pick the...

The canoe is probably an explorer, if it's 16 feet it's the most likely. That closeup of the hull looks like peeling paint. If so, just...

Look up Skillsaw method before you proceed. I'm sure Jim Dodd will be along shortly to make the case. Mark

I don't know if this video has already been posted, but it was obviously produced in support of the BWCA wilderness act. In spite of the...

That's quite the adventure. I am surprised nobody has paddled that route. I've been to Pond Inlet where they're starting. They're going...

Open canoe on the coast of Baffin Bay pretty much sums it up.

Another one to check out is Caltopo. I have an annual subscription. I can trace out routes on my computer at home which are...

Yes Brian. I was wondering if anyone would mention this. Mark