TravisH

I have the 3/16" bits, but opted for the 1/4". There is enough cove with the 1/4" bits, to hold the strip in place, and to me ? That's...

I think I mentioned this before as well, the 1/4" B&C is fine... to a point, then they start to kick out of the cove because it is...

The Jimmie clamps are like an extra hand, I use them to hold the strip in place, while I work clamping strips to the forms. . I still...

Hate to point this out Cruiser, but: You may have Travis beat on Jimmy Clamps, but his shop is impressive! Yours is still neater than...

Oh, please... let's not drift the thread to shop cleanliness! I live by "a place for everything and everything all over the place".

Most of us tend to be our own toughest critic (not always a bad thing) and all you'll hear when done is how amazing it is. Like most...

You can never have too many

Instead of bugee cord, I used rubber roofing cut to 1" wide strips, bike tubes, and movers straps, which are like large rubber bands...

I think I'm being picky because you can't see through any of the cracks I mentioned, they're just not as tight as I'd like. I could see...

The dowel is a good idea, I know i won't have room for those clamps soon enough, so thanks for that suggestion. I have found that I...

Great progress. Personally, I like to use more Jimmi Clamps .... my form spacings are ~`13.5" and I use 3 JCs between forms. In the...

Progress picture of where I'm at. It's been going pretty good so far. Only really issue I've noticed is, since my strips are just...

I only had blow outs on a few of the strips, and it didn't seem to help by changing the feed rate. And all the router bits are new, so i...

I completely understand what you are saying about the bit lifting the wood grain and didn't even consider that. I could only imagine...

Thanks, I appreciate the kind words and of course all the tips.