Foxyotter

In 1987, after a training run with Tom Ploski and me on Section IV of the Chattooga and the Ocoee earlier that year (😜), Nolan Whitesell...

Just found this on Facebook market place in St Johns Mi. I think it is the Sawyer Cruiser mold...

I have either applied abrasion plates to quite a few (two dozen or more) Royalex canoes that have worn through at the stems or repaired...

How do you think most other fifteen foot 36 inch wide tandems feel to paddle from the center compared to your raven? You will regret...

Honestly I have no connection to West Systems besides happy customer. Pblanc I assumed the outer compromised areas would be cleaned...

Off course all preventable deaths are are not good but 160 seems pretty low. Especially considering what percentage of people paddling...

Make sure to flame treatment and alcohol wipe. Significantly more adhesion...

https://www.jamestowndistributors.com/product/product-detail/802 I have used with success Ready Strip Marine to remove varnish from...

Very cool. I think I might rather use that paddle over some of the plastic steel paddles.

I’d have had a problem with that too. Bit of an anti-authority streak here, combined with an indignant sense of fairness. I have since...

The Jordan river in East Jordan, MI, sometime in middle school around 12 yrs old. Just day paddles, and lazy cruises. It’s a fun river...

No need to bring that extra paddle. Gunnel bobbing is surprisingly effective yielding about 2 miles an hour if you can keep it going...

PacketFlend I think I understand what your saying. Are you mostly thinking about small catamarans and monohulls like for racing etc...

PacketFlend I think there would be many a old salty captains that would disagree with you. There are more monohull sailboats sailing...

I had this problem with a couple of my kayak paddles. I cleaned them many times and was unable to determined what exactly catches. I...