memaquay's latest activity

Looks like it is around $1300 for basic kit, with add ons up to $2000.00 US, so like a million bucks Canadian. Sell it and buy a second...

Lol, Jim actually said it a few responses up the page. This is now my new favorite way, I looked at the sawstop fence today, and go...

I have used variations of this jig but tend to stick with a featherboard; if I have to manufacture isometric strips to even begin using...

We are dealing with an open pit gold mine. Despite lip service to environmental guidelines, it is proving to be an ecological disaster...

one of my tablesaws had the same problem of creeping a bit when you locked it down, turned out that the rear hook was slightly out of...

Yes. I had the same problem with our Saw Stop. I'm not saying it's a fault of the saw. You just have to be aware of it. The locking nut...

I can't take credit where it's not due. While my daughters are both capable of such artistry, I am best suited to following the path of...

Ended up trapped in training h@ll longer than expected, so only got 10 boards cut up. Ran into one problem. The fence in our table saw...

Today was glassing day and I made one addition before wetting out the cloth. I wasn't going to mention it in this thread but I'd swear...

Sounds like you have it handled. Good luck with the sneaking off part ! Ha ! Jim

Making progress on the stem bands,

I'm working with 8 foot by 4 inch, so pretty manageable. I do keep my eye on the jig, if one of the boards is slightly wider and you...

I may fill the next (I doubt that I'll pull the cloth off of this one) and my decision may come down to timing. If I can epoxy it...

You might be on to something, a clear canoe would be very cool. Plexiglass comes pretty thin too, sure wouldn't want to bead and cove it...

I could be wrong, I usualky am, but if doing multiple boards at the same time without moving the fence for each board, I can't see how...