Roybrew's latest activity

Good looking canoe. Unfortunately I know nothing about how to repair those areas. I look forward to hearing, with pictures of course...

Well, prompted by some discussion here and elsewhere, in which it seems that the Morningstar has a small but devoted following as a...

No walleye here, I fish for largemouth smallmouth and trout on fresh water. speaking of grilles, I put my grill on my paddle board a lot...

Thanks again for the advice. Did a little sanding on the hills Going to run a strip of tape down the center to section it off. I'll let...

That is exactly how I do it

Yes it is a nice setup. Do I smell walleye on the grill? I've never had lake trout, yet. Welcome aboard. What's the registration laws...

New to the forum, 33 yrs old and fish in southern Maine in my 1971 Radisson 12ft Canoe or on my paddleboard. Just got a hand-me-down...

Outside in the sun seems like it would be poor lighting and I'd worry about keeping a wet edge. Too many bugs out there too. Inside...

I find if you roll on a thin coat and then tip it off with a foam brush, the varnish rarely runs or sags. I have to admit, my standards...

I recoat my SR kevlars every couple of years with Epithanes mostly to improve appearance and perhaps provide some UV protection.

Thanks Alan. I went out this morning and got a fresh can of the gloss Minwax, all I can find around here. Rolled a coat on the one I'm...

I tend to agree with Mem that your top coat is going to have very little effect on damage resistance. I can see a stronger top coat...

I hope it helps. I used the table saw on my first build, and it did good, but the boards had to have 2 square sides. I used saw mill...

Thanks for the video Travis

Thanks for the advice. I saw the Interlux brand when I was researching yesterday. I used the US Composites resin on the first build...